Klean-Strip Logo
Print Page
Step 1:

Prepare work area and secure bumper to appropriate fixture. Clean bumper thoroughly using Klean-Strip Prep-All Wax and Grease Remover.

Step 2:

Wipe off Wax and Grease Remover with cloth, until dry. Apply Bulldog Abrasive Cleaner.

Step 3:

Use a pad to abrade the area.

Step 4:

Rinse thoroughly with plenty of water. (Important: Do not wipe surface with any type of solvent after rinsing.)

Step 5:

Wipe dry using a clean cloth and air hose. Once the plastic is ready for Bulldog Adhesion Promoter (see sidebar), proceed with Bulldog application. If water beads repeat steps one through five. Then move the bumper to paint booth and clean using a tack cloth and air hose.

Step 6:

Move bumper to paint booth and clean using a tack cloth and air hose.

Step 7:

Once surface has been prepared, add Bulldog Adhesion Promoter to spray gun. Use 100% Bulldog for clear spray out or mix 90% Bulldog with 10% basecoat for visible color coverage.

Step 8:

Apply two to three light coats of Bulldog Adhesion Promoter, allowing it to flash 3 to 5 minutes between coats.

Step 9:

Apply basecoat wet on wet per manufacturer’s instructions. Use Bulldog as a flex agent by adding a ratio of 1:4 Bulldog Adhesion Promoter with basecoat.

Step 10:

Apply clear coat per manufacturer’s instructions. Use Bulldog as a flex agent by adding a ratio of 1:3 Bulldog Adhesion Promoter with clear coat.